Anuncios Clasificados
INTRODUCTION The DMX shield is an add-on (or "shield") Compatible with Arduino Motherboard. It is an easy way to use as a DMX-Master device. Compatible with Arduino Motherboard, just by adding the DMX-shield on the top of it. This DMX / RDM Shield is a low cost high quality solution that allows you to connect your compatible with Arduino Motherboard driven artwork into DMX512 networks. The shield is populated with high quality NEUTRIK XLR 3pin Connectors (1x male and 1x female). The MAX485 based shield can be used as DMX Master, Slave and as RDM transponder.A unique RDM device id will be handed out from out range to you as well, this will make your device worldwide unique. The following settings are configurable via the onboard jumpers: - Send data via TX or Digital pin 4 - Receive data via RX or Digital pin 3 - Hardware slave mode or Software Controlled Slave/Master via Digital pin 2 (Required for RDM) - Enable / Disable shield In case you have the shield configured to use the RX and TX pins you have to disable the shield before you can upload your new sketch onto the Motherboard. This jumper allows you to disable the shield without disconnecting it from the Motherboard which saves time. WIKI http://www.cqrobot.wiki/index.php/DMX_Shield_for_Arduino-CQR0260 SPECIFICATION Remote Device Management DMX Master DMX Slave SHIPPING LIST 1 * DMX Shield
- http://www.cqrobot.wiki/index.php/DMX_Shield_for_Arduino-CQR0260
- Compatible with Arduino Motherboard, can very easily access it to DMX512 network.
- Do not need to buy expensive equipment for loading protocol change.
- Equipped with high-quality NEUTRIK 3-pin plug.
- Ensure a reliable connection with other music devices.
*** Todos nuestros productos son exportados desde Estados Unidos hasta tu casa!
*** Cualquier pregunta no dudes en contactarnos, estamos para servirte!
Anuncios Clasificados